Procedure for SLH radio controls
To complete the copy, follow the procedure as indicated
- Start copying until the "Check operation" screen
- Press the menu button at the top right to enter manual recording as in the image below
- Move the upper slider to 1 second and the lower slider to 5
- On the control unit, press and hold the SW3-LOGIC button (highlighted in red) and, keeping it pressed, also press SW1-SETUP (highlighted in green)
- Press the " Send source code " button on the app.
- The LED will remain lit for approximately 1 second indicating that the procedure was successful.
- On the app, press the " Send opening signal " button and wait 3 seconds
- Press the " Send opening signal " button again
- If it opens successfully, press "OK, I'm done" at the bottom and finish the wizard
If not, try again from point 4 of the guide