E24S (Rolling Code)

To complete the copy, follow the procedure as indicated:

1. Start copying until you reach the "Check Operation" screen.
2. Press the menu button at the top right to enter manual recording as shown in the image below
3. Move the top slider to 5 seconds. Do not touch the bottom slider.
   
   
4. On the control unit, press and hold down the SW3-LOGIC button (highlighted in red) and, while keeping it pressed, also press SW1-SETUP (highlighted in green).
5. Release both buttons.
   
   
6. Press the " Transmit opening signal " button within 5 seconds on the app.
7. The LED will remain lit for about 1 second, indicating that the procedure was successful. It will then start flashing again. Wait until the LED turns off.
8. Click "Next" and press the round "Open/Close" button a few times.