To complete the copy of your remote control
- Start copying until you get to the "Verify Operation" screen
- Press the menu button on the top right to enter manual recording as in the image below
- Move both sliders shown to 4 seconds
- Locate the display and the 3 buttons used for menu navigation: " + ", " - " and " OK "
- Press the " OK " button, if " Param " does not appear on the display, press " OK " again
- Use the " + " and " - " buttons to reach the " Radio " item and press " OK "
- Use the " + " and " - " buttons to get to the " Add start" item and press " OK "
- The message "Hidden button" will appear on the control unit, in the 1Control app press the " Transmit source code " button and wait 5 seconds
- When the message "Key desired" appears on the control unit, press the " Transmit opening signal " button on the app and wait 5 seconds
- The display should show " OK " followed by a number
- Wait approximately one minute for the control unit to exit programming mode.
- Press the " Next " button at the bottom of the app
- Test the storage operation using the " Open/Close " button
- If the test is successful, press " Ok, done " at the bottom, otherwise you need to follow the procedure again.