To complete the copy follow the procedure as indicated
- Start copying until you reach the "Check Operation" screen.
- Press the menu button at the top right to enter manual recording as shown in the image below
- Move both sliders to 1 second.
- In the gate receiver at the top right there are 3 buttons ( +, -, OK ).
Use the buttons to reach the radio item and press OK , then select the “ Add start ” function, press OK - The message "Hidden button" will appear on the control unit, in the 1Control app press the "Transmit source code" button and wait 2 seconds
- When the message "Key desired" appears on the control unit, press the "Transmit opening signal" button on the app and wait 2 seconds
- The display should show "OK" followed by a number
- Wait approximately one minute for the control unit to exit programming mode.
- Press the "Next" button at the bottom of the app
- Test the storage operation using the "Open/Close" button