- Start copying until the "Check operation" screen
- Press the menu button at the top right to enter manual recording as in the image below
- Move both sliders to 5 seconds
- On the receiver, press the P button for 1 second, the LED slowly flashes blue
- Place the SOLO near the receiver (in the same way as the remote control in the image above)
- In the 1Control app, press the " Send source code " button and wait 5 seconds
- The LED quickly flashes blue and turns off
- Wait approximately 1 minute
Press the " Send opening signal " button, the garage should open
If after the last step the garage is not operated, repeat the copy and the indicated procedure again.