Warning: Disconnect the power supply from the control board before starting any wiring.
Any existing cable must be left connected, and if the SOLO KIT connection uses the same contact as other wires, the new cables must be added to those already present in the same contact.
The control unit in question has an energy-saving mode active by default that deactivates the power supply to connected accessories after the opening and closing cycle has been completed. To be able to use the SOLO KIT device, it is necessary for it to be always powered and always "listening" for incoming signals. To do this, move dip switch number 4 to the "ON" position, i.e., move it upwards as indicated in the diagram:
