Remote copy procedure

Position the original remote as shown in the following image.



Press and keep pressed the button 1 and at the same time press 4 times the button 2 of 1Control QZero remote. The red LED starts flashing. Release the buttons.

Press the button on the original remote until the LED on the QZero starts to flash rapidly and then release it.

Press the 1Control QZero’s button in which the remote control is to be stored.

The copy is finished. Stand 20 meters from the gate/garage and try to open it, if it does not open, follow the calibration procedure.

Calibration procedure

Please note: If your remote control has a frequency close to 30MHz, such as 30.9MHz or 27MHz, you should not need to calibrate QZero.

Stand 20 meters from the gate/garage you want to open

Open the front cover of QZero using the screwdriver provided

Locate the hole between keys 2 and 4 and gently insert the screwdriver



Press and hold the QZero button you copied to

While you are pressing, slowly turn the screwdriver clockwise until the gate/garage opens.

When the gate/garage opens remove the screwdriver, the calibration is finished. Close QZero